The mounting rods are still the same ones raymarine sell today, so just buy another. Failure to undo the switch will destroy the switch. If you need to dig deeper into the unit, the centre of the on/off wheel picks out and the clamp holding the wheel on can be released, then the pcb pushed up using the wires. If shorting the switch does not work then there are a number of IC on the upper pcb that control the compass and the jog control. If you power the unit up and the short the contacts with ascrewdriver i should drive one way and the other switch the other, this will prove if the switch is definitely duff. The jog switches used to just stop working, they are micro switches and can be bought from the usual sources. The compass is trapped between the upper circuit bpard and top case so will fall out when you open up. Raymarine Autohelm Autopilot Linear Drive Unit Mounting Foot R18144. Mount the cluster and map it to a drive using the Map Network Drive tool or from the command line. If you get a screwdriver under the central label there is a scrw which will release the dial, then another two crews underneath. Autohelm 2000 3000 Wheel Pilot Autopilot Power Bulkhead Connector 2 pin with cap. The unit in question is an Autohelm 2000, it is what was refered to as an analog model. Re: Manual / Circuit Diagrams for Nautech Autohelm QVC to Lay Off Nearly 2,000 Workers After Massive Fire at Distribution Center.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |